I used the bestfromvcmiiclone china….yep..it’sSP177-C1.

I used a dell latitude d630 with clean install windows 7 32 bit professional.

I installed the Ford V.86.

I opened the Bosch VCI manager and updated the VCM II to work with Ford v86.

I installed Suzuki sdt2 software, and when the install asked me to connect theVCMIIiconnected the Ford VCM II and continued with the install.

Once it finished I opened the BOSCH folder, then VTX-VCIsub folder, and copied the entire contents of the VCI Software (Ford-VCM-II) to VCI Software (6516-Suzuki). Replace all files !!!

the Suzuki software will see theVCMIIas the OEM VCM even that the VCI managersayits a FordVCMII.

Theregeditwill look into the folder VCI Software (6516-Suzuki) for all the drivers, and it will load the Ford drivers to make it work.

DONE.

Remember to open VCI manager and connect the VCM before you go into the Suzuki or Ford software.

I connected a 2015 carnonUSAmodel and worked perfectly.

I also connected other USA model cars and worked OK.

I tried on Suzuki swift 2001 g10a, SuzukiwagonR 1.3 2007′, andSuzuki swift diesel 1.3 2011 , ALLWORKED FINE!

I mean it’s not able to do programming VIN orecuprogramming ifdatabaseis NOT had it….but diagnose is ok……..

I hope this helps !!

Btw, you can change Ford VCM2 Device type to SDT2VCI ,Then you havea SDT2VCI.

So if donglenotworkwhile it is a Ford vcm2, maybe it would work after you changed the VCM2 Device type to SDT2 VCI.

Cheers ..

Note: VCM2 clone can work with a lot of software. Look here:http://blog.obdexpress.co.uk/2018/04/25/ford-vcm-ii-a-lot-of-software-can-work-with/

Hide Comments | Add Comment