Here’s the tested result of tuning chip differences between UPA-USB and Xprog-m ECU programmer. UPA USB chip tuning is good in doing MOTOROLA chip while X-prog m supports on-board and in-circuit programming of better following chips including Motorola 68HC05, 68HC08, 68HC11, 68HC(S)12 family MCU's, Texas Instruments TMS370/TMS374 family MCU's and serial EEPROM's.

UPA USB Programmer Support the following chips:..

STMicroelectronics ST62*: ST6240, ST6245, ST6249

NSC CR16*: CR16HCS5(9), CR16MCS5(9), CR16MES5(9), CR16MFS5(9), CR16MCT5/9, CR16HCT5/9

Motorola HC05*: MC68HC05B6, MC68HC05B8, MC68HC05B16, MC68HC705B16, MC68HC05B32, MC68HC05E6, MC68HC705E6, MC68HC05H12, MC68HC05L28, MC68HC05P3, MC68HC705P3*,MC68HC05X16, MC68HC05X32

Motorola HC08*: MC68HC08AS20, MC68HC08AS32, MC68HC08AS60, MC68HC08AZ32, MC68HC(9)08AZ32A, MC68HC908AZ60, MC68HC908AZ60A

Motorola HC11*: MC68HC11A1, MC68HC11A8, MC68HC11E9, MC68HC11EA9, MC68HC11E20, MC68HC11F1, MC68HC11K4, MC68HC11KA2, MC68HC11KA4, MC68HC11KG4, MC68HC11KS2, MC68HC11KS8, MC68HC11L6, MC68HC11P2, MC68HC11PA8, MC68HC11PH8

The XPROG-m supports in-circuit or on-board programming of：

Motorola 68HC05 , 68HC08, 68HC11, 68HC(S)12 , HC912, MC9S12, MC9S12X

Texas Instruments TMS370 , MPC5xx, ST10Fxx, ATmega family MCU's

serial EEPROM's

XPROG-m programmer is fully upward-compatible hardware with XPROG programmer and have many additional features.

All supported devices are divided into "Software authorization" licenses. You can obtain authorization license only for these devices you are interested in.

NOTE:

UPA : Cannot read secured mcu / Xprog-m: Can read secured mcu

UPA : must have knowledge to use with processor / Xprog-M: Must be good in soldering / desoldering

Posted by: OBDexpress.co.uk at 09:13 AM | No Comments | Add Comment
Post contains 217 words, total size 3 kb.